All Categories > Musical Instruments & Equipment > Live Sound Equipment
Number of Channels: 8 - RCA
ART T8 - 8-channel transformer isolator with passive audio interface (XLR, 1/4" jack and RCA connections on all inputs and outputs), 8x high performance transformers, reversible rack-mount ears, separate input and output signal grounds reduce hum, audio transformers have an extremely flat and wide frequency response, very clean and neutral sound with a wide variety of signal sources, can be used for signal taps or as a signal splitter. Dimensions: 19 /1USee prices for: ART T8
See prices for: ART TubeOpto 8
See prices for: ART Tube Pac
See prices for: ART DTI
signal processor
ART CleanBOX II Hum Eliminator - hum in an audio system is often caused by loop effects which act like antennas. These loops can easily pick up a 60Hz (or higher harmonics) hum transmitted by electrical wiring. Typically, these loops are connected via grounds, more commonly called 'ground loops'. The safest way to eliminate unwanted noise is with the Cleanbox II. Some examples of ground loops: the power ground of a synthesizer, connected to the signal ground of the synth, into a mixer s ground, then into a ...See prices for: ART CleanBOX II
See prices for: ART ZDirect
Number of Channels: 3 - Stereo - USB - microphone
ART USB Mix, 3-Channel Mixer and USB Audio-Interface, Inputs: Balanced 1/4" TRS inputs for stereo or mono line-level sources, balanced XLR Mic or unbalanced 1/4" Instrument inputs with switchable impedance, wwitchable +48V phantom power, Outputs: 1/4" TRS output jacks (work with balanced or unbalanced lines), Headphone-Out, Green/Red LED signal/clip indicator, Switchable assignment of USB playback to channels 2 and 3, USB bus-powered, 44.1/48 kHz, 16-Bit, incl. USB-Cable and Power Supply. Dimensions: 41 x 101 ...See prices for: ART USB Mix
microphone
ART S8 3-Way - 8-channel, 3-way microphone splitter with passive interface. One direct and two transformer isolated outputs per channel, balanced XLR input and 3x balanced XLR outputs per channel, extremely wide frequency response, rack-mountable.See prices for: ART S8-3-Way Microphone Splitter
RCA - Speaker Size: 88mm - Maximum Frequency Response: 10hz
ART DJ Pre II - phono preamp with RIAA EQ, acts as an interface between your turntable and your audio recording / playback system. analog input capacitance can be switched between 100pF and 200pF to optimize your phono cartridge response. Switchable low cut filter, gain trim control and signal/clip LED, The line output jacks are low impedance and can be used with any sound card, Input- and Outputconnectors: RCA, Frequency Response: 10Hz - 50KHz, +/-.0,5dB, Dimensions: 106 x 44 x 88 mm, Weight: 570 gr.See prices for: ART DJ Pre II
See prices for: ART Prosplit
microphone
ART S8 - 8-channel microphone splitter. Can be used to split eight balanced low-impedance microphone signals into sixteen (eight pairs). One direct output and one transformer-isolated output on each channel, direct outputs pass phantom power from the input for use with condenser microphones, ground-lift switch on each isolated output, pad (attenuation) switch on each input. Rackmountable.See prices for: ART S8 Microphone Splitter
Optical - 10db - microphone
ART Pro Channel II, discrete Class-A Tube microphone preamp, Optical Compressor with separate Attack and Release controls, Auto/Manual Attack/Release switch, Parametric EQ, VU and LED meters, Multi section clip monitor LED, two insert loops, +4/-10 dB switch, 1/4" High Z input, XLR Mic-Input, Line-Out XLR balanced and 1/4" TR unbalanced, 19" 2U, Dimensions: 89 x 483 x 233 mm (HxWxD), Weight: 5kgSee prices for: ART Pro Channel ii
Number of Channels: 3
ART Promix, compact 3-channel mixer.The Promix can accept three Mikrophonsignals (XLR) and mixes them down to a mono signa (XLR). Additionally, it provides a headphone output. Specifications: Maximum Gain+60dB, Input Impedance 600 ohms, Maximum Input Level -14dB, Maximum Output Level +14dB, Output Impedance 600 ohms, Total Harmonic Distortion>0.02%, Adapter included, Power 12V DC (included), Dimensions 143mmx92mmx45mm, weight 680gSee prices for: ART Promix
See prices for: ART Pro VLA II
See prices for: ART Tube MP
See prices for: ART XDirect
See prices for: ART Tube MP/C
See prices for: ART DPS II
microphone
ART Splitcom Pro - split or combine low impedance balanced microphone signals. Low distortion with wide frequency response, two functions in one box, combines and/or splits, phase invert switch for subtractive combining, galvanic isolation to block phantom power between channel, ground lift switch to reduce ground loop noise, XLR inputs and outputs.See prices for: ART Splitcom Pro
sponsored links
Surf Become and find exceptional online deals on live sound equipment products featuring fabulous online prices and free shipping offers. If you happen to be searching for a specific item, refine your product query and filter by category to find exactly what you want for a fraction of its in-store price. Get all the shopping information you need in one spot with holiday shopping guides, comprehensive tip centres and the latest product reviews. So cut out the stress and add up the savings on Become UK from a variety of trusted online merchants and save a few quid on Become today!
About Become UK |
Shopping Blog |
Exava UK
Our International Sites: US Comparison Shopping | DE Ihr Einkaufsratgeber im Internet | FR Comparaison de prix | IT Confronta i prezzi | JP 価格比較サイト
Copyright © 2012 Become, Inc.
